Spyder® Halo Fog Lights - 05-09 Ford Mustang GT V8

When buying a new car, it often is a waste of money to purchase all the extra options right then and there. Buying OEM fog lights from the dealer can be EXTREMELY more expensive than buying aftermarket fog lights and putting in a little elbow grease. That's why Tuner's Depot is happy to offer a wide selection of affordable aftermarket fog lights for your vehicle, some of which even featuring exclusive colors and features not available from the dealer.
Please be advised that professional installation is recommended for these foglights, unless you are very comfortable running wire and installing electrical components in your vehicle. Though they can be installed easily if you are just replacing factory units, additional components may be required for a new installation (wiring and switches are not included with most applications).

• Many vehicles (especially trucks and SUV's) come with fog light harnesses pre-installed. Check around the area where the foglights are supposed to be installed and you may find stock harnesses taped inside around (usually above) the installation area. Please check for this before running a new wire harness.
• As with all light bulbs, never touch the glass of the light bulbs with your bare hands. The oil from your hands can stick to the bulb and make it explode. Either do not touch the glass of the bulb, or use clean rubber gloves while installing.
• You may get a check engine light on your Ford Mustang if you install foglights without resetting the computer. To prevent this (and for safety) you should disconnect the battery before installing fog lights onto your Mustang, and reconnect the battery only after installation is complete
• If you are picky about how your dashboard looks, you may want to go to the dealer (or a junkyard that has a Mustang with fog lights) and purchase a stock fog light harness and switch. These can be easily used with Spyder fog lights.
• If you plan on using an HID kit with your halo projector foglights, please use a low watt kit (usually 35w) as high watt kits (usually 55w plus) run hot and could damage the projector lenses on your Mustang fog lights