Ford Fusion Cold Air Intakes, Performance Air Intake System
Ford Fusion Cold Air Intake and can be a great way to get a quick and easy boost in power for your Fusion. Cold Air Intake systems work in the same way: rerouting the stock air intake delivery system for the best performance out of your Ford Fusion. Normally, the air filter in your Fusion is located in the engine bay where it can be easily accessed and replaced. The problem with this is, the heat of the engine bay has adverse effects on your engine’s performance.
The Fusion Cold Air Intake systems we offer extend the air intake tube to a lower position in your vehicle to collect denser (colder) air away from the hot engine bay. Also, the air filter is moved into a frontward position allowing for the cool air to be “rammed” into your engine, hence the term ram air intake or air induction intake that is used sometimes to refer to Fusion intake Pipes. This combination of cold and dense air being shot into your Ford Fusion’s engine results in immediate and noticeable performance gains.
Our line of Ford Fusion Cold Air Intake carry thru
2010, 2011, 2012 or 10, 11, 12 models.
10-12 Fusion Cold Air Intake
Ford Fusion Cold Air Intake System Frequently Asked Questions
Can I install my new Cold Air Intake myself?
If you have a decent amount of technical knowledge and can follow instructions, you should be able to follow the instructions and install a cold air intake onto your Ford Fusion yourself. K&N FIPK intakes by far offer the best instructions with multiple pictures, though AEM is close behind.
What kind of power can I expect to get on my Ford Fusion from an AEM, Spyder, or K&N FIPK Cold Air Intake?
Power increases vary by application, but you could expect anywhere from a 3-15hp increase under optimal conditions.
Are Cold Air Intakes safe in the rain?
NO CAR should ever be operated during flooding. Unlike short ram intakes, cold air intakes draw air from a relatively low position. Your vehicle can technically ingest water from rain puddles, streams, floods, etc if your car is lowered or the water is deep enough, and damage your engine. To prevent this, you could install the appropriate sized AEM Bypass valve onto your Ford Fusion’s AEM or Spyder Cold Air Intake, however, we instead recommend switching to your vehicles stock intake system if you anticipate driving through flood conditions. K&N FIPK Intakes do not require bypass valves since their design is higher than AEM and Spyder, and are relatively safe from water ingestion.
TunersDepot Ford Fusion Cold Air Intake System Reviews & Ratings (2)
Our 2 Cold Air Intake System Reviews have an average rating of 3.0 out of 5 stars. Every customer can leave a review about our service and the product that was purchased. In order to leave your review for the purchased product, please log into MY ACCOUNT after you receive your order. We encourage all of our customers to take the time to share their experiences with our website with everyone.
Posted on Feb 24, 2017 by Chevychris94
- (2010 - 2012 Ford Fusion)
Sent me the wrong stuff horrible parts dealer
Posted on May 12, 2016 by sadat_piggee
- (2010 - 2012 Ford Fusion)
Sounds awesome and is helping save a couple miles a gallon. Didn't come with the correct size of fitting for one of the parts, bit the rep that I spoke with was very professional and when I sent the email about the part issue; they had the part to me in a few days. Pretty awesome! Thanks.